EM-282; DC-motor controller 12-42V 100A; high current output

Código do produto: EM-282

EM-282; DC-motor controller 12-42V 100A; - high current output

 
- brake load output
- current limit
- current limit for brake also
- zero current limit
- speed setting
- flexible control inputs
- impulse / continuous mode
- rail base mountable
- digital parameter setting 
 

Catalogue in PDF

 
EM-282 is a full bridge DC-motor starter. It is designed to work with DC-motor in applications where some special functions are needed. Starter has adjustable acceleration and deceleration ramps, which make possible the smooth starts and stops. Adjustable current limit protects motor against overcurrent and there is also current limitation for brake ( regeneration ) . This device has also two settable speeds, which are useful in positioning applications. Control inputs FW and BW start the forward and backward run. STOP is for the motor shut-down but there are also available individual limit inputs for FW and BW directions. SPEED-2 input activates preset speed-2, but it can also be used as input for analog speed control signal 0-5V. FAULT terminal has at the same time input and output function, the pin is normally high, but is pulled down in overheat and conditionally also in current trip situation. If FAULT-line is pulled down externally it will cause a stop and prevent the new start. For example, it is possible to link fault pins of several units together and achieve a syncronous stop. There are 2 selectable control modes, contionuous and impulse. In continuous mode the motor runs as long as the control is active. In impulse mode a short comand starts the motor, and only a new impulse will change the status. The card has selectable input logics. Inputs are divided in two groups, control and limit -inputs. Groups can be individually set for NPN or PNP logic. The parameters are set with EM-236 interface unit. Operation of the controller and some of its functional values can also be monitored with EM-236 interface unit. 
 
TECHNICAL DATA
 
Supply voltage 12-42V ( 10-50V )
shutdown voltage 10V
Overvoltage limit adjustable 15-50V
Idle current typ 20mA
Motor current max. continous 100A ( at 25°C amb temp),
80A ( at 60° amb temp ) and peak 200A ( 5s )
Braking load current max cont 50A peak 100A
Current limit adjustable 1-200A ( at start 1.2 times )
Overheat limit 100°C
Start and stop ramp adjustable 0-5s
PWM frequency 2kHz
Speed input scale ( speed-2 ) 0-5V = 0-100% pwm
Input control logic: high =4-30V, low=0-1V
Control input impedances typ. 10kohm
Control input response time typ 5ms.
Fault out. NPN open coll. max 42V / 0.5A
Fault in actives Uin < 1V ( NPN )
Motor and supply connectors 16mm²
Control connectors 1mm²
Dimensions 180x122x60mm
CE-tested for industrial environment ( EMC )
Operating ambient temp ( Ta ) -40...60°C
Weight 750g
 
EM-282-DC-motor-controller-12-42V-100A-high-current-output-drawing

Acessórios

Produto Nota Estado Preço
EM-236; INTERFACE UNIT EM-236; INTERFACE UNIT
Mostrar detalhes do acessório

Procurar também nestas categorias: electromen, Controladoras de Motor, Catálogo